![]() ![]() When both the port and VLANs have monitors attached, then VLAN monitor will overwrite the port monitor for traffic comingįlow monitor type and traffic type (type means IPv4, IPv6, and data link) should be same for the flows to be created. Only permanent and normal cache is supported for the monitor immediate cache is not supported.Ĭhanging any monitor parameter will not be supported when it is applied on any of the interfaces or VLANs. One monitor per interface is supported, although multiple exporters per interface are supported. Monitor attachment is only supported in the ingress direction. Predefined flow records are not supported. IPv6 flow monitor-Configure the match ipv6 destination address command.ĭatalink flow monitor-Configure the match datalink mac output command. IPv4 flow monitor-Configure the match ip destination address command. For the different flow monitors, you must configure the following Is detected based on the destination IP address on the device. When a flow monitor has the collect interface output configured as the collect field in the flow record, the output interface ![]() When a flow monitor has configured the collect interface output command as the collect field in the flow record, the field will return a value of NULL when a flow gets created for any of the following addresses: Only NetFlow Version 9 is supported for Flexible NetFlow exporter using the export-protocol command option. ![]() The following restrictions apply to Flexible NetFlow and Flexible NetFlow Lite:Ĭisco TrustSec monitoring is not supported.Īccess control lists (ACL)-based NetFlow is not supported. VLAN-Monitor attachment is supported on VLAN interfaces onlyįamiliar with the Flexible NetFlow key fields as they are defined in theįamiliar with the Flexible NetFlow non key fields as they are defined in the The physical interfaceĬould be a routed port or a switched port. Port-Monitor attachment is only supported on physical interfacesĪnd not on logical interfaces, such as EtherChannels. Want to enable Flexible NetFlow: Cisco Express Forwarding or distributed Ciscoįor attaching a NetFlow monitor are the following: ![]() Catalyst 2960-XR is not stackable with theįollowing must be enabled on your device and on any interfaces on which you Is supported on the Catalyst 2960-X Switch and the Catalyst 2960-XR Switch withĪ Cisco ONE for Access license. ![]()
0 Comments
Leave a Reply. |